As of September 2014 the FI is in this state, mounted on the GL1000, ready for electronics. There were a number of adjustments I had to do in order to fit everything in place. That said, you must realize that fitting is a part of this kind of customization, so be not afraid, just make sure you maintain the structural integrity of the frame. When I began this project I spent some time reinforcing the frame just for this purpose.



 Right side showing fuel pressure regulator, fuel rail, injectors and plugs that injectors fit into.

 Front view showing throttle position sensor and wiring harness.

 Left side, fuel rail. I had to use a couple of  3/8" nuts as spacers to move left stiffener forward to clear TPS, at left.

 Looking down, front is to left. Note that I removed the cross bar to clear for fuel crossover tube. Also note, I removed bottom half of the two gussets. One is visible over the pressure regular, it is close, but does not touch.

 Looking from right side of bike you can see where left fuel rail clears the left side gusset.

 Here you see the pressure regulator, having had the fuel rail shortened and the mounting flange rotated to clear frame where lower half of gusset was removed.

 Fuel filter mounted where mechanical pump used to reside

Left side showing external fuel pump mounted under tank. I may do an in-tank fuel pump at a later date.

Fuel Injection Install

This installment shows the FI as of September 2014, there was some adjustments that had to be made to get it all in as planned. Aside from a couple minor issues, I am pleased with the look of the thing. I hope to have it running in a couple of weeks, given availability of time to work on it.


Here we have the induction viewed from the right side, I had to shorten the fuel rail in the foreground and re orient the pressure regulator to fit in the space allowed, this includes removing the bottom half of the gussets at the rear cross member. Nothing a visit to Harbor Freight can't solve. Bear in mind that I had done extensive frame reinforcements in the early stages of bike construction, just for this reason. I do not recommend removing structure without compensation.

 This view is from the front, TPS is visible as well as the wiring harness.

 View from left side of bike.

 Looking down , front is to left.